Counting matching models…
About This is an update to the (Un)original Prusa Drybox to keep it stable on the top of the Prusa enclosure. By default I think its perhaps a little to close to the edges for my taste so I designed some stabilizers to prevent the box…
A remix of a great earphone holder which improves the ease of printability. Designed for 0.4mm nozzle at 0.2mm layer height. No supports required. I printed with 3 perimeters, 10% gyroid infill and concentric top/bottom layers
A simple bracket to mount a Stream Deck Neo to my Sim Lab GT1 Pro cockpit. I attached the Stream Deck with a thin cable tie to keep it in place (pictured). I then attached the whole thing to my rig with M8 T-slot nuts and M8x12 bolts.…
My parents moved into a new house and the ignition button on the existing gas hob was missing. I, therefore, designed and printed them a new one I've included the 3mf with my settings. 0.2mm layer height Position the hole upwards I used a…
A simple laptop stand which is very strong and holds a Dell Latitude 5440 or similar laptop. The design allows unobstructed airflow for the fans so it will not impact cooling performance The opening is 21mm so it may be suitable for other…
I recently had a failure on an injection moulded part on my sofa. Rather than try to source a replacement I decided to print one. The picture above is the non-parametized prototype. I parametized this to allow it to be adjustable for any…
These are all currently available results.
