Counting matching models…
I was looking for a card separator for the Pokemon TCG to divide the different types of cards but only found stuff related to Magic the Gathering. So here's my rough take. The separators are just high enough to see the top of it over the…
An under table attachment for a vaccuum (inside diameter 41mm outside diameter 51mm) that fits my Delta Beaver 28-200 14" bandsaw.
From the original model, I modified the main holder so that the new screwdriver fits with its new USB-C. The USB-C part is more DIY that the original though. Also made them one part instead of two parts. Found that the original calls for…
I wanted to have a nozzle cleaning brush like the Vorons, so I made this remix of thing:5219287 by taka0909, of which I use on the other corner to help with the PEI sheet placement. Here's the macro I use with this. Please do check that…
I hated that stock filament sensor, so I made this part to help get the filament on the back instead of on the side.
A different top brace for https://www.printables.com/model/317867-z-brace-frame-support-cr6-ender-3-vyper-cr10-adapt that replaces the z-axis top support for the Anycubic Vyper. It replaces the top brace in the original model. Like the…
A wax purity seal featuring an octopus.
An underdesk support for a hot glue gun, this one made specifically for the Surebonder DT-270. Keep the wire support in the “open” position to secure the gun.
An underdesk support for a mini heatgun, this one made specifically for the Seekone mini heatgun. Slight angle to prevent it from falling, inner diameter is 46mm.
A guide block holder that fits many older bandsaws. This one works A-1 with my 28-200 Delta-Beaver 14" bandsaw.
This is a hard case for a Mangmi Air X handheld. The top part has 4 variations to it : it can be plain/bare (with no extras), have only the console's shadow, have only the hole to permit the charging of the console while having the case…
Couldn't find a hanger for planter boxes fitting a 2x3 railing so I made one.
I made this bracket to replace the stupid strain gauge sensor since I replaced it with a BLTouch. I also wanted a better PTFE support so I came up with this. It is made to fit on the Hero Me Gen7 universal base. It shouldn't interfere…
A lot of standard upright/trailing vaccuums have these spiral/sping tubing that can be repurposed to a lot of nice stuff around the shop. Some have attachement integrated to the line itself (like in the photos). I made one for this kind…
I needed to face mount an XL6009 to up the 5v voltage from a usb-a source to 12v in order to power a fan to cool my laptop. Made this little thing. Photos featuring the 140mm hexagonal fan grill from here :…
These are all currently available results.
