Counting matching models…
I designed this, so it can be printed on the Ender 3 as well (because my modded Ender 3 is simply much quieter). It uses 8 M3 T-nuts and screws (use at least 8mm long ones, 10mm are most likely easier to install) Print instructions…
If anyone wants to build upon this, I would recommend to start with the Gen 2 version instead. This is a part cooling fan mount/duct, that I designed for lipki's direct drive extruder design: https://www.thingiverse.com/thing:2665491 This…
My previous design had an issue, where the homing could fail violently, because the carriage, which has the thing that triggers the endstop, would stop at the bed, while the wobble fix would continue to go down until it was tightly…
I have mounted the orginal bearings upside down and added more in the old place of them to make the carriage more rigid. But this also meant that the wobble fixes from others wouldn't work anymore for me. So I designed my own anti wobble…
This is a simple replacement insert for the Aukey microphone arm. It is far longer than the original to limit the amount of wiggle and to limit the effect wear has on its function.
Due to the mod done by Morpheus_79 ( https://circuit-board.de/forum/index.php/Thread/26421-Etwas-mehr-aus-einer-ZD-915-Entl%C3%B6tstation-rausholen/ ) I wanted to add a step down converter to my ZD-915 too instead of the old 5W resistors.…
This simple cover was designed to protect the backside of the tester and have the battery easily accesible, but not dangling behind it. It uses 4 M3 8mm screws (but smaller screws would work too) Print instructions Category: Electronics…
I only had M3 T-nuts, so I remixed it. To compensate for the smaller screws, I increased the amount. Category: 3D Printer Accessories
I used round small levelling wheels before, but couldn't get enough grip. Especially with those wheels in the back, that are hard to reach. Since the printer didn't allow for any bigger wheels, I instead created knobs, that are easier to…
Unfinished project. This is a part cooling fan for this design: https://www.thingiverse.com/thing:2665491 parts needed: 40mmx40mmx20mm radial fan 5015 blower fan a bunch of M3 screws and nuts Category: 3D Printer Parts
This is my modified version to fit an original (non-pro) Ender 3.
This Echo Dot holder is designed to fit a Gen2 Echo Dot and keep it on top of a 57mmx45mm wooden bar. All these values can be changed as parameters in the design.
This Echo Dot holder is designed to fit a Gen2 Echo Dot and keep it on top of a 57mmx45mm wooden bar. All these values can be changed as parameters in the design. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports:…
Slight modification to use a cable chain Category: 3D Printer Parts
This Z-axis adjustment knob has a M8 thread and can be screwed on the end of the lead screw of a i3-style printer with metric M8 threaded rods for the Z-axis. The main purpose is it to make adjusting the dual lead screw easier, so that…
Because I wanted to convert to this: https://www.thingiverse.com/thing:2665491 I couldn't use the old mount on the carriage side anymore. Therefore I designed a compatible new one, that slides over the backside of the extruder motor. The…
A simple replacement part for the Nintendo Score Master. It has a diameter of 5cm and uses a single M6 nut that is inserted with a soldering iron. Print instructions Print Settings Printer Brand: Creality Printer: CR-10 Rafts: No…
These are all currently available results.
