Counting matching models…
I really liked @Hawwwtan's magnetic remix, but I needed deeper slots for 10x3mm magnets and slot for the USB charging. In addition, I remixed the arrow to remove the background so it can be printed with a single color.
I have the RealTruck Bak Revolver X4s tonneau cover . The new design is much improved from the previous model, but the corner end cap has a tendency to easily fall off. I saw this thread about solutions and decided to model a solution.…
This is a rough model. I'd like to clean it up a bit in the future, but so far this works.
I really like both Sneaks' articulated arm system and the DELACK enclosure. Coops combined the two for a top corner bracket mount. This is my attempt to adapt his model for a corner foot mount to have a platter level view for my camera.…
Refilling tool for Birdbuddy feeder. I found it awkward to refill the feeder without making a mess. After searching I found the original author's model and I remixed it have the tool hold in place.
This is a replacement corner wall piece for a DELACK enclosure skirt which adds a small cutout for routing accessory cables. In my case I wanted to route a webcam cable at the front lower corner of the enclosure skirt. Print instructions…
Remixed the bin holder by @dwbmb to allow easier bin insertion and removal with at least one spool holder attached. Print Parameters No supports are needed PETG 0.2mm 25% Gyroid infill
These are all currently available results.
