Counting matching models…
This should fit any of the Eufy Robovac 11 models. .5mm pitch, 46t gear that often strips out when the side brush gets jammed. The only other replacement option I found was replacing the entire motor assembly and those had month long…
Print both halves and four feet then screw in some motherboard standoffs and glue the pieces together. Fits a standard mATX motherboard or Mini-ITX motherboard. I printed with no top and bottom layers and a hexagonal infill, this make the…
Print it, glue it, sand it, stand it. Add some M3 set screws + 5mm M3 square nuts to secure rear IO. These are the parts that I used to get the rear IO forwarded: https://www.amazon.com/gp/product/B081JPBJJJ…
This is a drop in replacement that allows an NZXT Kraken watercooler to be converted to a standard BSP G1/4 water cooling loop. Just swap the O-rings and screws from the original 3/8in barbfittings. Not sure how this needs to be printed,…
This is meant to replace the stock lit logo on 10-series reference cards. My computer is black and red themed, so the green LED of the stock card just didn't match. If you have multi-material printing, then you can print this as one part.…
This piece allows a second single slot PCI card to be mounted in the FormD T1 and still be fully supported by the PCI slot in the rear. This basically just supports the tab on the metal bracket of the second card. Use a 20mm and a 6mm hex…
These are all currently available results.
