Counting matching models…
My VLSUN V400 came with the wiring harness tie wrapped to a solid part of the effector. The result distorted the cable throughout its movement, and partially blocked the extruder opening, making it difficult to clean. This little clip is…
For most Video Analog board shields you will need 5 snaps - easy to lose or break, and sometimes difficult to remove. I printed in PETG .2mm layer with a 6 layer skirt, .3 mm away from the objets - on an FLSUN V400, and no, not anywhere…
Logic board Mac PRAM battery container for compact Macs and beyond. .2mm PETG no supports - I used a 6 loop skirt .1mm from the model. After printing, I added 2 lengths of solder leads leftover from capacitor recapping - a paper clip…
A glove box tray for the 2012 Fiat 500 POP. Print in PETG to survive the car heat.
TPU cushion for 2012 Fiat Pop wire loom that always dislodges. You might be able to jam the “grommet” into the hole iof the hatchback lid without cutting it, but I chose to slice it, then lopped off 3 mm to make it even easier to insert,…
An “Elbows Up!” keychain label. 104 mm x 20mm x 4mm. Printed in PETG .3mm layer height. Start with white, change colour to red, (PAUSE) in Klipper, at layer 11.
These are all currently available results.
