Counting matching models…
I remixed the design from BeardedSwede to use a PC4-M10 Coupling to convert my Neptune to a reverse bowden setup. I have uploaded a version that can be mounted with the stock shroud or the Hero Me shroud for the stock extruder. Also I…
Since I had a bit of water come into the 230V CEE plug I added to my VW T4 camper I designed a cover for it to keep it dry when not in use. It is designed to be printed from TPU so it can seal properly and keep moisture/water out. These…
I designed this cap to cover the Extruder stepper motor of the Neptune 3 Pro, since after upgrading the parts cooling it was exposed. Didn't like the look of that to much, and the reflections were quite annoying when making a timelapse in…
Designed this single and double PC4-M10 Coupling Holder for a reverse bowden setup on my Neptune 3 Pro. Mounts with a single M3 screw and can be mounted on the original spool holder. You can use just a single coupling or one on either…
I remixed the design from BeardedSwede to be able to fit when using upgraded dual 5015 cooling. It just uses a short piece of ptfe tube to feed the filament nicely centered into the extruder. For mounting you need 1x M3x16 and 1x M3x20…
Remixed the original model from muddymaker to easily fit a 6x3mm magnet without the need for careful alignment. I use this on my Neptune 3 pro, you only need to attach another 6x3mm magnet to the stepper motor axis with a tiny drop of…
Simple pad for the Würth Floor Jack 071554925, but should fit most similar floor jacks. This is to be printed from TPU, preferably ~95A. Do not print this in PLA/PETG/ASA, it can break! Use at your own risk. I lifted the front of my VW T4…
At the moment it is difficult to get a normal clip fan and the prices are high for cheap fans, so I designed this mount. With this you can just mount a normal Arctic Summair USB fan to 22mm or 16mm poles which gives you a high quality,…
Handle sleeve for the Würth Floor Jack 071554925, should fit similar sized Handles (~Ø34mmm). This is to be printed from TPU, then it should slide right on. Use some soapy water as lubricant to get it on easily. I also designed a pad for…
These are all currently available results.
