Counting matching models…
Mouse bracket for Ikea Skadis system. Measured to fit the Logitech Pop mouse, but will obviously also fit any mouse that is of similar size. Internal dimensions are 60mm wide, 37mm deep (not including pegs) and 60mm from the bottom of the…
Skadis boxes in 2 different widths. Post-it Long holds 6 packs of wide post-it notes. Watercolours holds 3 travel paint cases.
Small paint tube holders for Ikea Skadis. Two different versions, one has internal compartment width and depth of 18mm and the other 25mm.
I didn't need DC power, or 20v power, and didn't need to monitor my voltage - I just wanted to have it run from a USB-C cable. I like the looks of this one a lot so decided to be lazy and remix it. I removed the voltmeter, step down…
Two different lengths to accomodate different size spools. The smaller size spool holder was made with these spools in mind. Gap between the holes on the smaller spool holder is approx. 35mm. Gap between the holes on the longer spool…
Tray measures 28.8cm x 4.2cm(not including pegs) x 1.6cm. Holes are a smidge over 21mm in diameter. First foray into fusion 360 so it's not perfect, but works.
Arteza paint tube holder for ikea skadis.
I wanted to move the spool from the top of the gantry and wanted to use the original bracket that came with the printer, and finally settled on hooking it onto the cross bar of an Ikea Ivar bookcase. I printed with PETG, 0.2 layer height…
I wanted to mount my Phomemo D35 label maker onto my Skadis board. The container hooks were designed by CSD_Salzburg , I have included the file here for completion.
I needed a simple case for my cheap (and quite a few years old) VTIN action camera to use on my printer. I used the corner block from https://www.printables.com/model/415075-go_pro_ender_3_s1_pro and the upright from…
A bracket to mount the smaller of the Ikea Godmorgon boxes onto the Ikea Skadis pegboard. My boxes are quite old now so I'm not 100% certain they will work with newer boxes. The model is printed with the top face on the bottom.
A bracket to allow the Godmorgon box to be attached to the edge of a shelf (I use Ikea Ivar). I used 3.5mm countersunk screws, I use my box as a waste bin for the purge lines and wanted it secured near my printer in a way that would allow…
These are all currently available results.
