Counting matching models…
This remix of the Oral-B Stand has been designed to hold 2 toothbrushes. I took away the brush-head holder as wash them separately anyway. The bowl can easily be cleaned with water and soap.
Threaded container. 90mm x 100mm. Printed this @ .28 layer height.
This is a large simple Bolt, the thread and bolt head (nut) are separated by a left hand thread. The thread is hollow allowing for it to be used as a compartment. The term lefty loosey, righty tighty doesn't apply here with the left hand…
A simple spindle holder for my CNC 3018 Pro. Mounts at the rear of the X carriage with M5 bolts and T nuts. No supports required for printing. This will hold a 45mm spindle with it's 20mm nut attached. Spindle should fit nice and snug…
Just a simple vertical laptop stand to keep laptop out of the way. Screw down to the desk.
Needed a way to keep my parasol steady on my apartment balcony. The balcony structure is round and is approx 44mm in diameter. The Parasol is 22mm in Diameter. I'm using 5mm bolts with washers to secure the bracket in place. Print…
Including both Left and Right brackets with support brace Print Settings Printer: CTC i3 Pro B Rafts: No Supports: No Resolution: .2 Infill: 12% might have to shave off a little where the bearings go so the rods fit nice and snug
These are all currently available results.
