Counting matching models…
This is a re-upload from thingiverse and is NOT my design. all rights go to Ameno_TheCat on thingiverse. Here is the original description: "Hi, this is my 2U Rackmount pc case. You can only put a Micro-ATX motherboard with a very small…
I made this beautiful work of art based on a piece of AI generated art. I have no idea if it will print, but please try!
A small 4-bay nas that fits 4 3.5 inch drives and one 2.5 inch SSD. i designed this case for a mini-ITX motherboard from eBay with a A8-4555m from coinmine; the page is no longer up, but any mini itx board and pico-psu should fit as long…
a longer case designed for fitting an addapter board internally
The R5 is just a rebranded r7 240. I printed this and it works fine, just remove the grounding tape from the top of the DP port to make it sit flush. I do not own an r7 but I don't see why it wouldn't fit Category: Computer
The original model allowed the antenna to flop out and I wanted the antenna to stay internally, so I modified the design to fully encapsulate it. The added fins are to make it able to take more force since it needs to be printed…
I extended the PCIE “slot” for a longer card, as well as adding a 120mm fan for better internal cooling where the original model's 60mm fan isn't sufficient.
A modified 5.25 bay that is designed to use less filament and take less time to print than the original model. uses ~200 grams of material and about 13h at 200mm/s
A basic mount for a 5-port Ugreen network switch. Tolerances are tight, so either press hard or print this at ~101%-103%. This is the switch I used: https://www.amazon.com/dp/B0D9JBTBZB?ref=ppx_yo2ov_dt_b_fed_asin_title
Allows you to mount an m5stack Cardputer to the Cooler Master Qube 540 PC case
Modified torso to have pins integrated- results in stronger connection and much lower chance of arms and legs snapping pins off body.
I modified the right “ear” to fit an 80mm fan. the weird bulge is to accommodate the m-atx board inside since its flush against the front. Just print this instead of the right “ear” and you're good to go!
A adapter designed to sit beside a 10" case on a rack. It is 2u thick and holds 2 3.5" hard drives as well as spacing for a single 60mm fan to help cool the drives… I used this in my Nas, but there's nothing stopping you from using this…
A simple dust cover for oculink connectors I needed one for my oculink EGPU enclosure, so I designed this Mine printed perfectly with a little tight fit at 100%, but you may need to adjust it slightly depending on your machine tolerances
Polygon count turned down a bit; make sure to use the Cura lay-flat or prusa lay-flat feature. use a brim as well.
DISCLAIMER: THIS PRINT REQUIRES YOU TO LITERALLY DRILL HOLES INTO THE BOTTOM SHELL OF YOUR LAPTOP! PLEASE CONSIDER THOUROUGHLY BEFORE GOING THROUGH WITH IT! EDIT 10/28/25: Added left and right connotations since it might vary where the…
I needed something pretty specific, so I made it! it mounts 2 raspberry pi model 3s, as well as a uGreen SD card/cf reader, a 40mm fan, and a single panel-mount 30mm-spaced USB 3.0 header. This is the SD card reader used here I would…
I had a little solar powered power bank from Blackberry cybersecurity that i decided to tear apart and build into this. It uses any 11.5 mm momentary switch for power. The power bank I used and disassembled seems to be this model. Be sure…
These are all currently available results.
