Counting matching models…
An unresponsive yoyo that takes a standard size C bearing, 12mm axle and slim 19mm response pads. Smaller axle can be used with a thinner bearing. I used a centre trac bearing, and aliexpress pads. Printed with 100% infil, 0.6 line width…
Cable wrap for the Karcher K2 and K3 models. I have a K2 and the K3 has the same hook. Looks like the K4 and above have a different system. Clips onto the cable gland under the hook quite satisfyingly! Personally I printed with 0.6mm line…
Keychron K2 case heavily based on one by OngXeno. I wanted it to fit more tightly so it doesn't slide off, and also be flat instead of curved.
Spacer to change the angle of the Next level Racing GT Lite chair. I found the standard angle was too far back for me, so I created these spacers to make the chair more comfortable. Would recommend support under the part unless your…
Button cover for the SONY HT-G700 soundbar. I created this because my cats kept sitting on the soundbar and pressing the buttons. Fits nicely as standard, but I added some foam on the rear side (see photo) to add a little grip.
These are all currently available results.
