7 models
I used Spectrum Filaments PETG HT100 which has a temperature resistance of 100 °C. Which means putting the cookie cutter inside a dishwasher is no problem. Because this material is prone to warping in sharp corners, I also added a 3mf…
I discovered that the suction of the hotend cooling fan cools down the left side of the heated bed. I measured differences of about 5 °C between the left and right side. Also I don't like that the angled part cooling fan sucks in more…
Why I created this After 2-3 game sessions I spottet some wear on some tokens. To preserve a nice appereance of the tokens I created this protective shell / case. Print instructions Works best with a flat print surface (not textured).…
When I change my summer / winter tires I like to keep track at which position each tire was mounted. The commercially available tire markers I used before were breaking easily and often fall out of the rim. Also they weren't very visible.…
I uploaded three sizes (10, 15 and 20 mm ring diameter) but mostly use the 15 mm ones. Print Settings (or use the attached clips.3mf file) 3 perimeters 0 top layers 0 bottom layers 0 % infill Prusas 0.3 mm preset: 0.3 mm layer height 0.5…
I don't like that the original Prusa MK3 uses one of the y axis bearings for the end stop detection. This means that the bearing gets rammed into the rod holder everytime the printer homes his position. This puts an off center load on the…
I redesigned the original Prusa z screw cover in Fusion 360 to have a movement indicator. It's meant to be printed with a color change, where the second color starts at height 5 mm. With Source file I have added the .f3d source file as I…
These are all currently available results.
