Counting matching models…
A small riddle that show interesting capabilities of 3D printing. Inside is a 75xD10 mm box for a congratulation letter / important note / whatever. Print instructions You need two nuts and each screw once (the nuts are the same, the…
This is a little mod for the MK3s to add a 608 ball bearing per Z spindle at the top end. The Z motors need to be a few mm higher (additional length of the spindles at the top end to fit into the bearing) so there also new mounting parts…
The frame at the beginning of the case at the left side was broken, but all electric cables was still intact. The headset couldn't be used anymore, there was no pressure on the left side. With this case it will work fine. Print…
Easy to print heaset / headphone rest with original IKEA screws on the table. You don't need any additional parts. Print instructions 5% infill is enough Changelog: 22.03.2022: One part design (no more cones needed) add right version
This is a continuous clearance test for your printer. With this test parts you can choose a clearance suitable for your task. Print instructions General information: The hole and the pin are cones with 0,01 mm diameter change per mm…
A long time ago I got this LEGO set as a present from my dad. Because I like to drive fast and the RC control is only binary I crashed a few times and the jumps of the included big cardboard ramps did their part as well and the front…
This is a spring loaded clamping mechanism to mount the Kensington Orbit trackball to a sim rig. The spring allows easy access to the device for example for battery change, power switch or if it's too far away for easy use and should be…
I needed a 2430 battery but only had some 2016 laying around. This is my solution. The 2016 cell overlap the adapter to achieve some contact at the side of the cell.
A carrier for two ties. One hanger fit at least 5 tie carriers. Print instructions The ring should be print with more wall layers, so there is no space for infill.
These are all currently available results.
