Counting matching models…
I was asked by my girlfriend to make a Menorah for her office as there was an abundance of Christmas decorations but limited on Hanukkah representation, so here is my first attempt at a Menorah! I included a test thread piece to check the…
This is a quick model I put together when I couldn't cut consistent 10 mm length silicone tubes for the silicone bed mod. Works with the recommended 7 mm OD automotive silicone tubing and the cutting slot is 0.5 mm which works well with…
I created this clamp to hold looped cable together for stabilizing a telescope base, and alternatively as a wall/rafter anchored cable to prevent a TV from tipping off a dresser. A #10-32 thumbscrew or alternative screw threads through…
This is a very basic clip that slides over the edge of the print sheet and heat bed to keep the magnetic sheet down during large prints. I ran into an issue when printing large parts for the Prusa enXLosure, specifically the parts that…
These are all currently available results.
