All models

Counting matching models…

Malolo's screw-less / snap fit Raspberry Pi 3 Model B+ Slim Top Case

a much thinner version of malolo's top cover design (snug case like) so you can use the gpio pins more easily and I also emptied the run pin section in case it is needed. tips; if you have already printed the bottom part of the malolon…

Downloads: 227
Likes: 7
Rating: 5

Order a print of this model

PrintablesBerk Caglar

PTFE filament guide for Creality Space Pi/PluS

Pierre Moustache's design is for PC4-M6 ptfe adapter, what I did was to change it so that you can install it without PC4-M6 by pushing the ptfe hose directly. print settings are the same as the original line height: 0.16mm No supports…

Downloads: 135
Likes: 12
Rating: 0

Order a print of this model

PrintablesBerk Caglar

ZTE ZXHN F601 SKADIS MOUNT

You need to print upside down and supported, there is a supported version in the photos.

Downloads: 44
Likes: 2
Rating: 0

Order a print of this model

These are all currently available results.