Counting matching models…
Reasons to make a remix: Added a low-profile base to decrease minimal height to 72 mm Needed a flat bottom for an uneven surface Angular design Configurations: Low profile base + short screw: 72mm - 108mm Normal base + short screw: 80mm -…
Replacement knob for KORG nanoKONTROL2 Print instructions I recommend to print it in PETG with elephant foot compensation on. Infill 100% prints in about 15 minutes. No supports are needed but you might have to clean up the ceiling inside…
I am 95% sure it should fit with 8bitdo SN30 pro+ as well because they seem to have the same shape. If you have one, please print this and let me know if it works. For science! These are meant to be attached to a flat surface with…
I recommend to print in PETG. Use double-sided tape to attach to any flat surface. If using with sonoff motion sensor, use beveled edges to align with the sensor. Please post makes :)
I used modifiers to add infill and strengthen the base near the legs. I recommend PETG
Consists of two parts. One is a bracket that goes around the body of Artillery Genius. Another part is an interface between Ender 3 cable chain by johnniewhiskey and the first part. Chain that works perfectly with this part (you would…
I quickly adapted another badge model by LibDMC to use it with a pin. Model I remixed from: https://www.thingiverse.com/thing:3443374 Print instructions You can use M600 pause function in your slicer to change the color before the bridge…
A part that help to level either part of the sonoff door/window sensor. Beveled edges indicate which side attaches to the sensor or the magnet. It is possible to scale it to whatever height needed in the slicer to adjust for your mounting…
These are all currently available results.
