Counting matching models…
A Flexi-designed otter. The face, paws, feet have all been embossed up 0.5mm so that you can add in a filament color change for the final two layers. Or leave it single color and he's just got a bit more detail. Since the design includes…
A sponge (scrub daddy) holder. It's got a flat (give or take) bottom for sitting on flat counter tops. It's ramped internally so that any moisture in the sponge will run off into the sink. Plenty of ventilation to help it dry. While I…
Drop in dividers for the Ikea Samla 1 Gallon / 5 Liter storage bins (AN: 701.029.72) , cleaned up and optimized slightly. Print 2 clips, slide them over the outside edge, drop in a divider and it should pop-in to the clip. They'll stay…
This is designed for use with the GreenStalk Original Vertical Planter . It slips over the rim of the top water reservoir tier, fairly snug if printed in PLA. The ¼ inch drip irrigation tubing then slots into the top, with a little bit of…
A case for the Soldered Inkplate 10 - 9.7" e-paper board . Case files pulled directly from their GitHub , licensed under The TAPR Open Hardware License.
A very simple 1x2 gridfinity bin that stores 8 Raspberry Pi Pico or Pico 2's. Plain units only, no headers. Print with PLA or PETG, should have enough play for a little printer intolerance.
This is Gridfinity bin for holding a DJI Mic 2 Charging Case. It's low enough so that you can still open the case and access your DJI Mic's while sitting in the Gridfinity. My original print is in Jessie PLA. The f3d file is included and…
This is a Multiboard compatible holder for a Seeed Studio Wio Tracker L1 Pro for Meshtastic. This fits for exactly the case it ships with. Should print fine without supports. Requires a rail for the rear connection to the multiboard. Wio…
Print it at .2 to make sure the fits the snap, otherwise it should not require any supports. SenseCAP Card Tracker T1000-E for Meshtastic on SeeedStudio.com
I have several laser line modules that I use for halloween spook fog effects. The mounts they come with, if they come with one, are junk. Anything with any amount of possible play is dangerous. Kids come by and poke at it and suddenly…
This fits the M5Stack cardputer with a place to put the antenna on the back. It'll fit the non-mesh cardputer as well as the mesh version. This is generated using build123d, AI was used in the creation of the relevant python code.…
These are all currently available results.
