Counting matching models…
I got tired of reaching down to the floor to find my cable everytime i wanted to charge my phone in bed, so i made a cable clip so that it's always attached to my nightstand. Been using it for one month before this upload with no…
UPDATED: New mount with tighter fit Infill: 100% I used double-sided tape to attach the pen-mount to the portapack.
Say hello to my 19-inch rack 1U under desk mount . This sleek mount allows you to tuck your cherished audio interface securely beneath your desk, granting you more room and less cable hassle. Required: 4x Screws of appropriate length 4x…
Smaller knob for Portapack, makes it easier to both navigate and see battery status LEDs 100% infill if material is transparent
Recommended print settings: Wall: 3-4 loops Infill: 20% gyroid Ps: will NOT fit if you have a metal enclosure!
Print upright with brim.
There are two different t-clips, if your cradle sits too loose on your skådis, try the clip for the painted pegboards.
What you need: 4x M2 threaded nuts [ 2mm length ] 4x M2 screws [ 4mm length ] Glue [ for attaching the pad on the underside of the mount ] All parts printed in PLA with 100% infill. This is part of a project called NA_lily58 by…
I needed somewhere to store my bits for my Dremel, so i made this tool organizer. If you wish to have the text on the backplate in a different color, you'll need to perform a filament change at the layer where the letters begin After…
Custom-designed under desk PSU mount for Elektron Digitakt, allowing you to securely attach your Digitakt power supply unit (PSU) underneath your desk. Settings: layer height: 0.2mm Infill: above 15% Required: x2 screws of proper length
These are all currently available results.
