Counting matching models…
I had best results printing vertically with a brim, but, that takes significantly longer. Acceptable prints were made by using supports from print bed only and printing with the rail side on the bed. 15% infill .15 layer height 2 Perimeters
This is a model built from caliper measurements. It is exact as I could make it, as a reference model for case designs. Due to hand measurements and quality control between boards, there could be small variances from board to board.
Reference model for 3.5mm panel mount audio jack.
I found multiple Emisar flashing kit cases, however, they all seemed to be friction fit. This case has 4 locking tabs that double to keep the board secure in the case. The tabs can be fragile during assembly, but once locked in place…
These are all currently available results.
