Counting matching models…
This is a brass catcher for the Ruger 10/22. There are two versions, one that hooks onto the picatinny rails and the other that attaches with velcro or a command strip. Below are some instructions for attaching both models.…
This is a direct replacement for the 10/22 trigger. I have the upgraded trigger housing, but this should fit the standard one from pictures I've seen, can't confirm though. The holes are tight, so you have to drill them out with a 1/8"…
This mount holds a Vizio Sound Bar under my TV stand to hide it out of sight. One version has holes, else use VHB tape. I printed it using PLA and did 3-4 walls and no top of bottom layers to expose the infill. When Using VHB tape, sand…
I printed this at 0.1mm layer height since the filter threads are a 0.75mm pitch, best use as low as you can get and print at a slower speed. The fit is a bit loose until it's tightened down, but it's not going anywhere once in place. You…
These are all currently available results.
