Counting matching models…
Tape measure Holder No supports required, just rotate it with inserts on bottom. Also requires 2 empty inserts from original model. I uploaded 2 variations - with Honeycomb and without.
Updated with extruded font and added step file. Basic test that I made to see what font size to use on 3d prints (it does use Arial only). My test uses fonts 8mm-0,5mm cut into an object 1mm deep top and bottom. I might update it with…
Holder made for box LostVape Centaurus M200 but everything matching size (26,5x53mm) should fit. Additionaly 2 atomizer thread holes to hold them vertically and 3 holes for liquid (made for LongFill Gorilla but as above everything below…
Rail for a Honeycomb Storage Wall, that allows You to hang Ikea Sunnersta boxes on the wall. You will need 2 empty inserts from original project (included in downloads), that are press fitted int o wall and a rail. The project doesn't…
Bigger knob for original project.
Model doesnt require any assembly, just super glue for rubber parts. Box is 1 print with 0,4mm gap on hinge. Rubber insert is glued on both sides, on lower cut. Rubber cover has 2 models - both same size, but one has “NEO partial refills”…
After a lot of positive feedback from a forum i might just share it :) This station was made specificaly for those electronics and might not fit anything other than that (not tested): 3DConnexion Spacemouse Stream Deck MK1 Genius Numpad…
These are all currently available results.
