Counting matching models…
A simple, modern picture frame stand, with a low profile so that it is hardly noticeable. Fits 2cm thick picture frames and works for portrait or landscape orientation. Can also be used to stand up signs and other artwork. Can be printed…
A horizontal ID Card holder for lanyards, for those who have to wear them for work- modified to hold a card on each side. Remixed from https://www.printables.com/model/187124-id-card-holder-for-lanyards
Round electrical junction box cover plate for standard USA ceiling junction box. 5 inch / 127 mm outside diameter. 2.75 inch / 70 mm hole spacing. 4 mm screw holes. Center hole added to allow wires to pass through for a lamp fixture.…
Remixed from the level holder to hold a generic paper cutter (guillotine).
This is a wall mount for the Oral-B CrossAction and Pulsar battery toothbrushes. It likely fits others. There's a screw hole so that it can be secured permanently to the wall. Remixed from…
Mount for Mellow Fly Micro 4 Board with holes to screw into DIN mount bracket. This remix adds two small screw holes so tape is no longer required.
Wall mount for original plastic HDHomeRun Extend HDTC-2US. Remixed from https://www.printables.com/model/895655-hdhomerun-connect-scribe-duo-quatro-wall-mounts
This case holds a Raspberry Pi Pico 2040 zero (mine is from Waveshare) + sensor board with ENS160 and AHT21 sensors. It has a mounting hole which I attached to a 2020 extrusion inside the chamber of my Voron Trident using a t-nut. There…
This wall mount loops around the top of the Eufy RoboVac 15C Max Charging Base Station, keeping it stationary so the vacuum won't push it around the room anymore instead of docking. Fix the loop to the wall with a height near the top of…
I used the bottom set of holes and added an M3 heat shrink insert. Then, I used M3 screws to fasten one Prusawire mount to the left side and this mount to the right side. These mounts attach to the Prusa frame plate on the front of the…
40mm fan holder. Completely open so as not to impede airflow.
EBB36 mount for the ProosaXY Sherpa hotend. Thanks @Shoikan for the original!
Use a 1/8" drill bit (3.175mm) to make a hole through the broken side (where the peg broke off). Slide the peg through the hole and dab some super glue underneath. Two versions are included: lid-peg-fix: for if your drill bit went through…
Print two of these, attach to a DIN mount using M2 self-trapping screws. Then, attach the Mini-Rambo v1.3a board from your MK2 using M3 screws. This allows you to easily add a left over board you're no longer using from an MK2 to your…
These are all currently available results.
