Counting matching models…
Printing: Main Gouge Clamping Body - 40% infill or higher, print on flat backside Lower Hinge Post and Assembly - 75% infill, 10mm brim, print vertically Main Clamping Body - 40% infill Horizontal Base - 20% infill Follow JL Designs…
https://tormek.com/en/products/accessories/tts-100-turning-tool-setter Use setter for distance of tool bar and protrusion of tool from model. I use with: https://www.printables.com/model/1329063-svd-186r-tormek-sharpening-guide
This model uses 1/4-20 Bolt and nuts. ~2" of bolt or so works well. I usually print on the side with organic supports. 15% Gyroid Infill.
Print standing up. 25% infill. PETG
Print top and bottom 20% gyroid infill. Rotator at 5%. May require light sanding to get to rotate smoothly. Bolt holes are sized for 1/4".
Point arrow down and use whichever side you need for your angles!
Print on the top side. 15% infill with Gyroid pattern. Snug supports with support enforces under the hex wrenches and the chuck key. See photo! I designed for #8 screws to fasten.
This model can be used for teaching bowl turning. It helps illustrate the direction to cut so that you don't tear out fibers. For the outside of the bowl, you want to go from the base to the rim. For the inside, you want to go from the…
Print with brim and supports. I blocked supports in the middle and came out perfect.
Point arrow down and use whichever side you need for your angles!
These are all currently available results.
