Counting matching models…
I wanted to print some 17" wide Panoramas with my Epson SureColor P800 but want to spend $200 for the Epson branded one. 3d printing it cost less than $50 including hardware. For all parts I used .28mm layer height .4mm width at 30%…
This is a replacement bubble wand for Fubbles Bubbles no-spill bubbles. I made the opening a bit larger so its easier to blow a bubble.
2020 Extrusion Camera Mount for Standard 1/4-20 Screw Mount Logitech C920 or other Webcams. This was remixed for use with a printable ¼-20 screw. It includes a wrench to tighten it. To fasten to the 2020 extrusion I used a spring ball nut…
I wanted to keep my litterbox in the garage without needing to open the door for the cat do do his business. The solution was to design a portal to go between the studs of a 2x4 wall. The litterbox itself is a plastic storage tub. It…
I designed simple holder for Sheba Perfect Portions wet cat food. They don't stay put otherwise and I don't like emptying them into a bowl. Print with flat face on build plate. Just just about any material and normal print settings will…
Driveway markers never seem to stay put because I cant get them in the ground deep enough. I designed a hammer in stake to make it quick and easy. This is designed for standard inexpensive hardware store stakes that are around 9mm diameter.
I designed this Letter Tycoon Organizer for a friend so I thought I would share it with the world. This is designed to fit inside the original box and keep the pieces in place with the lid on. The letters were printed separately and glued…
These are all currently available results.
