Counting matching models…
This is a remix of Brad's https://www.printables.com/@FixThisBuildThat remix of a plate holder for Bambu printers. This print will hold the K1 Max lid, a glass bed (or magnetic base), and 2 metal sheets. Instead of adding custom tools, I…
This is a mount for the Yeti Blue microphone with RostaP's small arm system. Use the original mounting screws for the microphone to mount it to this mount.
BigTreeTech ADXL345 mount for Hero Me Gen 7
I had a Ring doorbell which takes up a larger footprint than the Ring Wired. Instead of redoing all of the brickmold, I chose to make this. The holes on the right side align with the previous ring doorbell mount plate as well. The left…
These rails with desiccant roller should make your Filadryer have less friction when pulling the filament out. I found especially with cardboard spools, when it gets toward the end of the spool, it like to bounce around in the dryer.…
I remixed this from a similar model I found on Thingiverse.
I used Thekroll's original filament guide and added a hygrometer holder and a chute to the outer bearing assembly. I've used the guide for months and found that sometimes the filament gets squirrelly and likes to pop out where I put the…
This model allows for pressing the M2.5 T-Nut onto the M2.5 hex nut without it wriggling around from under the T-Nut. Place the hex nut in the printed item labeled HexNutSide. Either apply equal pressure with fingernails on the T-Nut or…
I created this model because while the KVM was on the desk: The weight of the DVI cables made it pop up in the front. The cables from behind the desk were unsightly. The holes on the side allow for mounting using the built in rack mounts…
These are all currently available results.
