Counting matching models…
Designed a new enclosure. Main goals were: minimal as possible use the FlashForge kit as much as possible leave the screen mounted where it is all panels and door easily removable without tools design files are available for easy remixes…
Remixed from design8studio design to re-orient filament sensor - fixes filament reloading issues
Uses cheap 24V COB LED strip (8mm). Connects to rear motherboard using existing LED header. To make: 0.2mm, no supports (you'll need decent bridging), ‘outer face’ down on printbed. Superglue in magnets, slide in LED I was able to print…
The kegland nukatap mini and flow control disconnect is a pretty cool little widget, but flexes way too much in stock form. This brace clips straight on and reduces almost all the flex. I also tried a top pin - had a 2mm bicycle spoke…
Designed a ZCI for my table saw - figured I wouldn't reinvent the wheel, and make an insert for just the existing slot gap instead of the whole insert. Friction fits in the existing slot but works much better if you drill and tap the…
Holds regular sized 500g kewpie bottle upside down. Includes recess for double sided tape mount I printed with supports for the logo but you probably don't need to if your printer is tuned well.
Good model from cults, but the tabs were very weak. Beefed up the strength of the tabs and it works great now. Print with supports under the tabs Allegedly this remote is the one used for the following models of home theatre amp RAV521…
ZCI for AEG mitre saw Will likely be too big for you printer - use the Cut tool in Orca slicer to cut in half, I used two ‘dowel’ connectors to provide pockets for 2mm metal pins that I had lying around, use what you like though. See…
My microwave would always slide open when the door was pulled - this bracket (?) hooks around the front feet and uses double sided tape to stop that movement. I used Gorilla double sided tape, anything over 1mm thick should work. LG…
These are all currently available results.
