Counting matching models…
I remixed this to make it 15% larger to accomodate larger broadheads. It should still fit smaller heads too. I also adjusted the clips and hinge bars so they clip in and pivot better without falling out. 10% infill. No supports (used…
Use a straight piece of wood 90 to 100mm or deeper, 1100mm wide is enough to cut 35” arrows. I used 12mm thick wood, but a bit thicker can be better so you don’t have to use short screws. Based around a Dremel 395. It should be fairly…
Board clips in. Uses M3 screws to secure it. No supports needed. Be careful sliding the board in so the front fingers don't hit the PCB components. If top side tabs are too tight, trim them with a knife or side cutters. It's for the…
Suits sockets that fit 1mm and 1.5mm panels. Bolts to 2020 or 2040 extrusions Typical panel socket that fits it. https://www.altronics.com.au/p/p8341-c14-male-socket-chassis-snap-in-fused-switched-10a-iec/
Wall mounted holder for Remote pro RPC401
Marron are the largest freshwater crayfish in Western Australia. Gauge measures Both Trophy Waters(90mm) and Open Waters(80mm) Print instructions Printed in PETG for Durability. PLA should be ok. 10 to 40% infill. May need a Brim if it…
Use vacuum to suck grease into the being. Espcially bearings with a crimped in shields that can't be removed. Use are standard syringe with a 4mm tip (push on, not luer lock). 50ml is good. Or use a constant vacuum source, EG pump or…
These are all currently available results.
