6 models
after doing an enclosure mod with the stock door i noticed a gap on the side. this U shaped seal slips over the glass and fills the gap. not completely but well enough Print two in TPU, in the same orientation as the model. supports are…
Compatible with Echo 56v series batteries Print upright with the triangle points up. No supports, but brim is recommended 4-5 walls requires 3x countersunk screws M4 or similar
for anyone else that would like to use the stock chamber fan or no fan split in two pieces with a joining slot for easy printing. Untested as I'm waiting on hardware for the enclosure
Features Mounting holes for popular VESC based controllers – DV6/Stormcore/xenith/UBOX Power cable easily fits through the nose (and CAN bus cable for 4×4) The scoop slides out for easy access to motor wires Clamp and foam offer an easy…
it's a wedge that will help your board turn better, but the secret sauce is the captive angled washers. These washers will offset the angle of the wedge to eliminate the stress on the bolt BUT also, they hold the nut in place while…
These are all currently available results.
