Counting matching models…
V3.1 Is now released - New features; 2mm thicker top mount - 0 visible flexion now @ recommended print settings Added some parts to increase rigidity, moved cable tie hole Tidied up design -------------------- DISCLAIMERS: Print on TOP…
Requires - 2x M3 heat inserts (5mm OD x 4mm H). Insert into BOTTOM 2 outer holes - I chose to rear mount them for higher strength. — The Story — Wanted more than 10~mm^3 flow rate from the stock v2NEO hotend, also wanted to print above…
Will need some sort of washer+nut&bolt, or washer+spring, inserting into the back - can get some from online stores - 12mm OD required 99% sure the threads are M16*1.25, thats what I've modelled them to and seems ok if not a bit tight.…
30+ iterations and even more test prints later, I've arrived at a v1 of this belt clip replacement for the NCVT-4IR model voltage(pen) tester Tolerances around 0.1mm I printed in PLA+, 0.2mmLH, 5 top layers, 4 bot, 6 perimeters, no infill…
These are all currently available results.
