Counting matching models…
The eSUN box has a constant air hole when in use (but not connected to printer) which may allow moisture inside. I have created two options to prevent this. A plug which fits into the provided PFTE tube guide. This uses 0.66g of filament…
Added a very basic base to vivamus3d's model to allow a freestanding design. I got a multi pack of these hygrometers for around the house but needed something to hold them in place. Print flat and size is exactly the same as original…
Basic replacement leg for the NZXT PC case. Printed at 15% infill. I used 0.6 nozzle and printed at 0.3 but should work fine with your standard settings.
Remix of nyknyc's model to better fit some of the smaller devices running NerdMiner. This will save you filament, time and space :)
Headphone holder designed to fit the Ikea Malm desk, should hold any headphones unless the top is wider than 5cm. Print so the model lays on its side and with your usual settings. I printed using a 0.6mm nozzle at 0.3mm layers @ 15% infill.
Remix of Dani30s keyring adding loops to hold a metal key ring. There is both a square loop and a circular loop depending on preference. I printed with 25% infill and otherwise standard Prusa Balanced settings in PLA.
These are all currently available results.
