Counting matching models…
I have a wooden structure on the wall of my balcony for hanging some plants. Now, instead of using expensive and not-so-nice metal brackets that will rust over time, I can use my own custom-made planters that fit there perfectly. Update:…
Print approx. €5.68–€6.94 excl. taxPreliminary estimate for one variant
A previous model I designed used a piece of cloth or paper to allow gases to escape while keeping the bugs out of my one-gallon kombucha jar. It occurs to me a similar goal could be achieved with a tight infill. So, I returned to the…
Print approx. €3.34–€4.08 excl. taxPreliminary estimate for PETGSource material: PET
I know this may not be a good idea but I did it anyway ;-)
Print approx. €1.41–€1.73 excl. taxPreliminary estimate for PETGSource material: PET
Rotate the thicker part only , otherwise, you could run the blade into your fingers when putting it all together or when replacing the blade.
My wife saw the new AxiDraw and wanted one. http://shop.evilmadscientist.com/846 Unfortunately they will start shipping in June. So I had to do it myself during Easter holidays :-) I am not yet done but progress is being made and as it…
To score the surface of your bread with a shaving blade before cooking it. You will need: 1 blade 1 M3x8 mm contersunk screw 1 M3 nut Print instructions With the proposed orientation there is no need for supports.
I wanted to use Xiaomi's ENCHEN to trim my beard, but the original comb was too long. I made this one that does the job. Print instructions Category: Bathroom Summary I wanted to use Xiaomi's ENCHEN to trim my beard, but the original comb…
Using a small geared stepper it can rotate as slowly as you need. I am controlling it using a CNC shield v4 with an Arduino nano. It uses one 6809 bearing. https://youtu.be/rC\_dt6k4iSE And do not forget checking out this video in case…
Only suitable if you have the same 1 gallon (3.8 liters) jar as I do. It will keep a paper towel tightly fixed to the top of the jar so air can pass but flies cannot. It won't work if you use cloth (unless you cut just a disk).
For printing it on the Prusa XL. I joined the two sides with 16 mm PVC pipe cut to length and glued. It makes a portable ramp, better than the alternative.
Last time, the plastic lid fell somewhere not to be found. I printed a replacement that seems to do the job. Print instructions Licence: Creative Commons - Attribution Category: Automotive
Just what brother-in-law needed it. Print instructions Licence: Creative Commons - Attribution Category: Automotive
After paying almost $50 for a new switch that was similar to the old model no longer in stock I have at home, it was about time to design the only part that really needed replacement. Print instructions Unassociated tags: electric switch…
A built a supporting part to hold the two controller boards of a spot welder on top of the microwave oven transformer. Y used four 35mm long M3 screws to keep them in place. Some hot glue can be used to glue to frame to the transformer.…
I was experimenting with piezo inkjets. The first attempt was a no go (frame was not watertight). Please leave a comment if you have got something working using 3D printed parts. I know about these attempts that seemed to work:…
It printed well on the side with no supports and minimum clean-up with PETG.
These are all currently available results.
