P
PrintablesDigitehas
Hand ringholder
Hand shaped ringholder, can also hold bracelets and watches. Printed with 0.8mm nozzle @0.4mm layer height. 25% lighting infill works out good.
- Downloads
- 2,317
- Likes
- 295
- Rating
- 5
All models
Counting matching models…
P
PrintablesDigitehas
120mm turntable
120mm turntable / turnable base. To be used with 6904 ball bearing. The bearing fits snug, no screws or glue needed. The thing can take a decent amount of weight (>2kg) even when center of mass is tilted to one side, then it would rest on…
- Downloads
- 139
- Likes
- 22
- Rating
- 0
P
PrintablesDigitehas
Mini sanding blocks
Small sanding blocks good for post printing wet sanding. We like to use and created them to wet-sand earrings. Round one has 10mm radius. Flat one is 10mm wide with 5 degrees negative sidewalls for easier sanding in the corners. Effective…
- Downloads
- 95
- Likes
- 27
- Rating
- 5
P
PrintablesDigitehas
30cc / 55cc tube dispenser
Manually operated precision 3 part dispenser for 30cc and 55cc tubes/barrels. Does't require supports to print. Recommended layer height 0.2mm or below. 3-5mm of brim recommended. Takes around 4h15m to print with previously mentioned…
- Downloads
- 37
- Likes
- 9
- Rating
- 0
P
PrintablesDigitehas
30cc / 55cc tube stand
Stand for 30 / 55cc tube/barrel. One piece desin which does't require supports to print. 3mm brim is recommended. Print with 0.3 layer height or below, 10-25% infill, 2-5 perimeters. Note to position the bottom against the bed because the…
- Downloads
- 16
- Likes
- 1
- Rating
- 0
These are all currently available results.