Counting matching models…
This parametric model is perfect for the wall display of various medals. Because the portion that holds the ribbon is threaded, you just need 2 wall safe adhesive strips to mount it to the wall. The pull tabs extend into the interior of…
This is a parametric model of a drawer pull I designed for use in my workshop. It is intended to be used as a pair on a wide drawer. The back plate thickness is sized to make sure that the pan head screws I had on hand wouldn't go through…
This is the same as the parent model except for the addition of single layer squares to each Gridfinity pad to prevent printing hole perimeters in midair without supports.
The moulding around my door would not allow a Reolink Doorbell Camera to sit flush leaving large gaps for water/bug intrusion and complicating install. This OpenSCAD file contains a parametric model for an adapter that sits square to flat…
The Raymarine Autohelm 3000 is an automatic steering unit for sailboats that is no longer for sale. The drive unit is sandwiched between an engagement lever and this washer in the clevis mounted to the hull or binnacle (circled in Fig 16…
Introduction Webelos and Arrow of Light Cub Scouts are required to learn 4 knots as part of activities to earn their rank/award: Square Knot, Two Half-Hitches, Taut-Line Hitch, and Bowline. There are many knot board designs that for…
These are inserts inspired by https://www.instructables.com/Rain-Barrel-and-Diverter/ for a PVC 4-in x 2-in dia x Hub 45-Degree Combination Wye to turn it into a diverter for a water collection system. The bottom portion resembling a cap…
This parametric model uses gridfinity-rebuilt-openscad as the base for a holder for your Lego Brick Separator. It works equally well with the orange and teal separators in any orientation. TODO: Take the number of separators to hold and…
This model remixes the original to remove as much extra material from the base that goes against the wall as possible. The cutouts index for the placement of the no wall damage adhesive strips. Use lightning supports to minimize material…
This parametric model uses gridfinity-rebuilt-openscad as the base for a holder for your mxn array of Lego Brick Separators. It works equally well with the orange and teal separators in any orientation, and presumably green too. At the…
This model adapts the tapered inlet of the older, not 2.5, Oneida Dust Deputy to the slip end of a Cen-Tec shop-vac hose that is intended to go into a standard shop-vac. Both sides are just press fit onto the Dust Deputy and the end of…
This is a remix holding 8 wide mouth Mason jar lids with the sharp upper corners of the original rounded.
Improves (aesthetically IMHO) the original SCAD file with rounded over corners and edges. The mounting holes were also moved to the bottom to allow mounting to a vertical stud. The provided STL fits the power brick provided with the…
This model combines the stock 1.5" dust collector from the Maslow Not Shop with the base STEP file from @poprhythm. I recommend printing it with organic supports and increasing the spacing and separation slightly to improve their release…
While not parametric, this model is parameterizable. It is set up to hold 4 ¾" lengths of PVC pipe while you paint them. To use, print 2 holders and toe screw one to a 2x4 or similar piece of lumber. Load the lengths of PVC pipe to paint…
This cord keeper is designed to print without support. It holds a ¼" plug snuggly and allows you to coil the cord around the prongs of the print.
Years ago I built a PVC pipe supported stand to hold a cyclonic separator above my wet/dry vacuum in the shop. The locations for the pipe took up built-in locations to hold the tubes and other accessories. This led to endless searching…
These are all currently available results.
