Counting matching models…
This is a remix of Ethernet Port Dust Cap/Cover - No Supports from kerngebiet with a larger base for easier printing and easier extraction of the cover. The initial design was a bit loose in my ethernet ports, therefore I added a 105%…
This is a slightly modified version of the remixed design for a tighter fit of my European hinges. Modified sections are: Larger corner radius Larger screw adjustment clearance Flat middle section (less to print) Update 2023-06-09 Added…
Simple pan/pot lid stand/holder for your cookware. It is compatible for lids with up to 30cm diameter, but it can be stretched if more balance is needed. The original design is created by Lobsterdude . This model has been created by…
This model is based on the design of Ikea Skadis Xbox Controller Holder from Norm . I needed to change the inner radius for a better fit with the GuliKit KingKong 2 Pro Controller. In addition all edges now feature a radius, which…
I lost the rear wiper cover for my Alfa Romeo Mito and needed a replacement. It looks like a common design for various car brands and might also fit for others (not tested). I am happy for feedback and like to hear if this fits (or not)…
This simple Tape Measure Holder for Sola Pro-TM 3m uses the T-Clip System with low profile flush mount clips. At the backside is an alignment pin so that it can not rotate and that it only requires one low profile T-Clip. It can be…
A simple Orchid pot for IKEA MUSKOT 9cm that can be printed in spiral vase mode. The pot will rest on the inner lip/ring of the planter and floats around 2cm above the ground. It features a nice hexagonal pattern at the bottom for…
These are all currently available results.
