Counting matching models…
I made this as a lock is the only thing that Shimano should add to their derailleurs. This is for the 1x12 XT derailleur but looking at the pictures af the other Shimano 1x12 derailleurs it should fit those too. This makes it easier to…
I wanted a more robust clamp for my Playseat Challenge pedal base. And I still had to be able to fold it. And also the base has to be able to put on a angle without putting a lot of stress on the new clamps. I made this for M6 hardware…
Someone asked for something like this. This is made by measuring the original rubber foot.
This is an old design that I imported from my prints on Thingiverse. I needed to remove the top cap from the airspring on my Rockshox Sid. This can be done with a cassette tool but mine has a centre pin to locate it on the shaft/cassette.…
This is an old design that I imported from my prints on Thingiverse. I needed a bleed block after shortening the brake hoses on my new bike. This one works a bleed block and piston spreader. It works on the Sram Level TLM and Ultimate…
I modified the Rpi3b Prusa Mk3 Mk3s Frame Mount Case form 3D_Dynamics. I have used the case he based his design on on my old printer and the rpi would run a little hot sometimes. And I wanted it to look more like the Einsy case of the…
This is an old design that I imported from my prints on Thingiverse. As the original Trelock mount doesn't really fit the carbon aero cockpit on my Canyon roadbike I decided to make something myself. I never liked to have the light off…
I made a remix of a extruder motor cooler. This is for the new MK3s+ that has some airflow over the Bondtech gears. This one uses both openings on the left side of the extruder but doesn't block the tension screw for the Bondtech gears. I…
This is an old design that I imported from my prints on Thingiverse. I made this Di2 junction A mount for my Canyon H31 Ergocockpit with Garmin mount. This will hide most of the junction out of sight but you can still use all the…
This is an old design that I imported from my prints on Thingiverse. This is a remix from the parts needed to install a bottom bracked from https://www.thingiverse.com/thing:2303747 I made this to install a Sram GXP pressfit bottom…
Just a simple holder for the springsteel printbed sheets of my Prusa. These clip to the rails of the storage rack that I use at the moment for my printer. The sheets are placed on a slight inwards angle to keep them from leaning against…
I like to have some cooling for my Raspberry pi's but don't want to add fans if possible. And as I have a couple of Synology NAS's running anyway I thought I could use those. I made a 92 mm fan grill replacement for the Synology fan's…
These are all currently available results.
