Counting matching models…
This compact funnel fits right into the side of a camper to allow pouring in the water from a bucket to fill the tank. Neck is 29mm about 1-1/8". Printed upside down without support fine. Print Settings Rafts: Doesn't Matter Supports:…
A bit tough to print, but using a brim keeps the legs all in place.
My air nailer upper stop bumper cracked so I drew up this replacement. Works well in a Campbell Hausfield framing nailer and should be the same as other brands. Printed in TPU. Print Settings Printer: i3 Rafts: No Supports: Yes…
Keeps the door 65mm off the wall so the door handle doesn't hit. Print from PLA or PETG works ok. Thicker walls makes it stronger.
A handy keeper to help secure the door of a Weber gas BBQ. This prints well with PLA and snaps to the handles on the front and keeps them closed in the wind. My old grill has been through a few such windstorms and the magnets are not…
This single part clips over a Leviton plug available most places and supports it when pressed into a panel. I've printed it with PLA and there is enough flex that the plug securely snaps in. There is tabs 25mm back to support it in 1"…
These are all currently available results.
