Counting matching models…
Basic simple 2 colour Black center with white outside bullseye replacement for gun stock. Apparently you can buy them on ebay or amazon, but I just made them for a friend. PLA or PETG, 0.20, Brim, infill 100%, White and Black. Requires 2…
We ordered the scanners and the bases, but bases were backordered with ETA 6 months out, so we designed our own. Use 0.15, PETG, black or any other colour you like, in fill 100% to make it strong as possible. Its beet working for about 1…
After printing in PLA, lift the parts off carefully as they are thin. You can form the parts with hot air, I used SMT hot air soldering kit that I also use to clean off any fluff on bigger prints. I find 345 deg F works good. Glued with…
Friend bought an OutSunny 10 x 6.5ft Crop Cage, Double Doors Plant Protection Tent Black and the fittings started to break, so I replicated in TinkerCad and printed with PETG 100% infill, no supports, brim only in Straight as it prints…
Optex iVision video doorbell, with optional strike release, is rated water resistant to jet spray (actually one of the most water resistant on the market, especially better than consumer grade models). A commecial job site decided not to…
This plate with various holes sizes fits well with the patch panel name plate below. In PrusaSlicer I added BOLD names to be embossed on the name plate. You might have to round off the corners a bit as it is a tight fit.
We all love our electric knife, but after years of using the included thin plastic sheath it gets pretty busted up, so this is a replacement. 200mm x 25mm x 8mm with 2mm walls leaves the internal space at 21mm x 4mm and that post on the…
Where the wires exit my in-floor sump pump case, there is a large hole that debris can fall in. So with renovations underway and making for a nicer finish, I printed this cap with an opening to allow the power and high water alarm cables…
Changed the size to fit larger Outlaw Tuner+PS pedal, same thickness and repaired the original STL with Prusa and Windows algorythms. Because the steel backplate offers shielding and PETG or PLA does not, I added Conductive foil HVAC tape…
Replacement cap for nose and ear hair trimmer. PLA, no supports. Printed on textured sheet, but I'm sure a smooth one would work great too. Print Top down (Wahl on the print sheet). Had to rotate 180 degrees. Created in Tinkercad.
For all those that have FESTO KEYS (great addition), the selector pointer needs to be wider and the hole larger to fit.
Allows for velcro on PLA or PETG instead of the actual pedal.
These are all currently available results.
