4 models
Instead of a base with stairs, I decided to remove the stairs using TinkerCad to make stand compact. I used a 5% gyroid infill to save filament and print time. The base is still strong and does not tip over from the weight of the echo…
Print approx. €3.34–€4.09 excl. taxPreliminary estimate for one variant
I wanted to mount the LCD case to a proto board setup and decided mounting tabs with holes was needed. I placed the tabs to the bottom section using Tinkercad. They will now take a pair of #6 screws, placed 3.75 inches apart. Only the…
I used Tinkercad to add three magnet wells on the bottom of the puddle jumper and add extra support for the front magnet. Now as a fridge magnet, notes can be affixed to your fridge or message board.
Superglue works well to affix the magnets in the wells at the back of the print. There's enough strength to hold a sheet of paper as a note to a metal surface. Printing at .2mm with a 10% gyroid infill takes 7 grams of PLA for about 1hr.
These are all currently available results.
