Counting matching models…
This is a remix of the Voron 2.4 Bowden retainer that features an M10 thread at the back for a fitting that retains your PTFE tube . It's designed so that the fitting can be screwed into the back, and the tube pushed all the way through…
This model allows you to mount your Pi Camera Module 3 to any vertical 2020 aluminum extrusion. I designed it to mount on the side of a Voron 2.4, but it should work on other 3D printer designs too. Because of the angle, it's a particular…
Minimal paper towel holder, can mount to the bottom of a cabinet or to your wall. Prints quickly and without supports (see photo for orientation). Simply print two of them, measure the width of your paper towel roll, and attach using…
This is a wall or shelf mount for your Klein multimeter that also includes a shelf for the wires. I'm using it on an IKEA Bror unit with an M5x16 screw. Prints without supports, but does include a sacrificial bridge in the clip that…
This is a remix of NeedItMakeIt's model resized to fix Polymaker spools. It also fits perfectly in Bambu Lab and Overture spools. Use the same settings as the original: 0.7mm default line width All other line width settings increased by…
A slim mount for your Wyze Cam v3 on a 2020 extrusion. I'm using it on the back extrusion of the gantry on my Voron 2.4, so the gantry moves with the camera. You will need to disassemble your camera, see this video for instructions as…
This rack holds up to 5 pairs of small tweezers! It includes holes for 3 * 3x10mm magnets on the back. Use some super glue to hold them in. I found that applying a piece of electrical tape over the back really helps to prevent it from…
These are all currently available results.
