Counting matching models…
Over the past several years, I've used many different cell holders for testing batteries. I've tried many options from the cheap leaf spring cell holders to expensive aluminum-framed universal cell holders, but none of them got everything…
Parts are for the Large version of the Velobuild TT-023 frame only. Front compartment has just enough room for a spare TPU tube. Main compartment has a pull-out tool holder that fits my pump, multi-tool, allen keys, tire levers, and a…
Holder for wireless blips for ~19.2-21mm internal bar ends (most standard TT bikes). Hardware required: M4 washer M4 30mm socket head cap screw M4 nyloc nut Thin piece of ~1 inch diameter heat-shrink for extra peace of mind that the blip…
Print with 100% infill, and use a headset bearing press to hold it against the BB. Then a pipe wrench around the block to tighten it. Didn't slip at all, and the plastic was not even deformed.
Secure into the bridge with an M5 flat head bolt and use a larger arm pad to cover the increased area. Print with 4 walls for better strength, and a solid infill modifier around the bolt hole. Mirror the part for the other side elbow pad.
Case for this Isolated ADC Module .
No matter how much I tightened the bolt for the gopro mount (at risk of stripping the insert and plastic), the light would always slip. I designed this to act as a block to prevent the light from changing its angle when knocked.
A mount for the 64 channel data acquisition board by A2D Electronics available here . I printed the entire bottom plate with 0 top and bottom layers and hex infill to save filament and make it a bit more flexible to snap around the edges…
These are all currently available results.
