Counting matching models…
This two piece item joins the two ends of a cord - simply tuck the two ends of the cord into the inner piece and click it into place within the outer hood - now you have a handy thumb tab - great for zips on outdoor gear where you need…
An adjustable butt-stock for 13ci PCP air bottles for magfed paintball markers. This has a tightening position. You will need to adapt the tightening clasp and provide your own nut/bolt to your requirement.
This is a simple torch mount for the picatinny system - it gives clearance for a laser sight. Holds torch tightly. You can use standard A4 or A5 finger tight bolt and nut heads. Current inner diameter of the torch clasp is 26.2mm - Change…
This is a Driver Hex Bit holder with good fit that holds 35 Bits
This is a simple replacement part for the rear door compartment door-latch. The original part is weak by design and snaps in almost all cases - this new improved version of mine is a good substitute. Category: Automotive
This original support that I designed adds stability to the upright section of the Ender 3 series of printers - it is placed on the far right side of the base frame up against the upright pillar. It can be used as a single support, or two…
This is a simple 2 part device that you can attach to the inside of your Tush Spool Roller Supports. Just print it, no supports, and then attach using Loctite 406, just like in my pictures. It allows for the use of reels from 45mm width…
This is a protective barrier that prevents the moving hot end cable from rubbing and getting snagged on the power input plug. Simply print in one piece standing-on-end using tree supports, then slide it over the power unit.
Grip Arm/Washer to help filament loading for the Ender 3 Print on its back, flat with no support needed.
This is a kit to provide lateral support and a guide to any reel placed on the existing Vesa Spool Bracket. It ensures that the reel cant wind its way off and end up on the floor, spoiling your print. This happened to me. The parts are…
This device stabilises and adjusts the Y Axis Beam to ensure its perpendicular to uprights for perfect print geometry
These are all currently available results.
