Counting matching models…
Took the camera mount piece from luc.e tripod mount to make it work with the inner framing of the Qidi X Max 3. Simply slides onto the L bracing. No supports needed and I was unable to get the tiny screw back in the pivot post but its a…
Since doing rideshare part-time takes FOREVER to get a nice driver plate from either one of these companies I decided to make some that are much better than the stickers they issue. These are designed to work with suction cups with a 10mm…
Stickman it here! Supports are needed for the arms only. The arm sockets are small and fit snug but you can articulate him still. I did have to remove the “pupils” and just glued a piece of filament which worked great. You can glue the…
Print in place with a tiny amount of organic supports needed. Uses a small amount of PTFE tubing in the swivel ball. Use a blade to taper one end of the tube to make it easier to install.
The stock spool holder on the X2 is too large to fit smaller spools with a 41.6mm hole. This will snap under the carry handle with a little “convincing”. can be removed in the same manner. Neither the holder or the mini spools will…
These may interfere with the bulky stepper motor housing and ribbon cable if printing very tall objects. You can remix these any way you see fit just shout me out. Use organic supports for the small overhangs and at least 25% infill for…
Remix of a remix that holds 37 brushes. I enlarged the center hole for a chunkier brush 15mm, the rest are 10mm and added a base that accommodates a single 608 bearing. Designed to fit snug without glue. Added an enforcer to the bearing…
These are all currently available results.
