7 models
Filter stand for drying/storing the filter after washing it. Fits filters for Roborock S5Max and probably a few more Roborock models with the same filter size.
Print approx. €1.90–€2.32 excl. taxPreliminary estimate for one variant
I cut the original model into eight pieces to fit the 250mmx210mm build area of the PrusaMK4. Printed with 0.2mm layer height and PLA.
I created a case for these inexpensive reflashed TV boxes, to use as a replacement for unobtainable Raspberry Pis. The only parts needed are a 4010 5VDC fan and a 40mm heatsink. With this setup, the CPU never gets above 70 degrees C or…
A simple straightforward base for Roborock S7/S6/S5 so that the mop does not stain the floor while parked The design is meant to be laser-cut or milled out of thin material like 3/5mm plywood, or 3.2mm hardboard with a melamine top You…
Replacement for the buttons/middle plastic piece of an 895max garage door remote. It isn't perfect but it worked for me. I printed it vertically with the buttons up. It doesn't matter much cause it'll use lots of support either way. The…
A simple base for Roborock S7/S6/S5 so that the mop does not stain the floor while parked
