Deadblow hammer - tough PLA
The hammerhead, pin and wedge were printed at 100% infill and the rest were printed at 50% with 1.6mm walls.
- Downloads
- 25
- Likes
- 0
- Rating
- 0
Counting matching models…
The hammerhead, pin and wedge were printed at 100% infill and the rest were printed at 50% with 1.6mm walls.
Created using the FigBash beta figure builder program. FigBash is a digital action figure kitbash system. Create the action figure of your dreams by selecting its features, from hairstyles to clothing! These are 3.75 inch action figures,…
The Gridfinity bug is alive and thriving in my shop, so here is just another piece to the puzzle. Here are a smaller set of bins that together hold a generic brand 1lb dead blow hammer. The top side is 2x3, and for the bottom there are…
Mounting hooks for medium sized deadblow hammer onto a Skadis board, with about 54mm diameter. Fits the Harbor Freight Icon 24oz deadblow hammer. Print on the side. I used PLA 0.2mm layer height and 25% infill.
harbor frieght deadblow hsw mount can also be screwed into a wall
I wanted a small, deadblow hammer with replaceable end caps. I also wanted to seal the media inside so that breaking or replaceing an end cap wouldn't result in spilled media. For the media I used lead shot, but you can use sand, steel…
Mounting hooks for medium sized deadblow hammer onto a Skadis board, with about 54mm diameter. Fits the Harbor Freight Icon 24oz deadblow hammer. Print on the side. I used PLA 0.2mm layer height and 25% infill.