The source marked this model as adult content.
- Downloads
- 1,917
- Likes
- 559
- Rating
- 4.83
6 models
The source marked this model as adult content.
Made in Fusion over a couple of nights, I'd like to thank u/knowlessman and u/AnonymousHermit for measurements and photos of the key. Print settings that matter: 100% infill 0.12mm layer height or lower No supports See this door for the…
A colleague from work asked me to make him a model to raise his Alesis Mesh kit drums...I created a simple solution that allows you to adjust the height and be more ergonomic. Enjoy it…
Angled guitar pedal riser for better ergonomics. ...Cause I'm lazy and don't want to lift my heel off the ground... :) Made it for my Analogman Sunface but should work well with any 1590b hammond enclosure pedal. One version for minimal…
A narrower version of the controller key created by @ChadHendrixs_5476252. The loop is now 13mm wide, intended to fit the Spigen hand strap kit.
A weight for the Pine64 Pinecil V2 to improve the ergonomics and reduce the top-heaviness of the iron. When combined with two steel rods (D = 4 mm, L = 44.5 mm), the weight holder adds about 10 g to the iron, mostly at the back. This…