Search results: fizzi

Sort order

7 models

P
PrintablesSchwiftyProps

Sodastream Fizzi Button Replacement

Print sideways as shown for tensile strength. Add a 30mm M3 bolt and a square (hex works) nut. Some support needed between the holes but not much for easy removal.

Downloads
484
Likes
32
Rating
5
P
PrintablesDeun's factory

Bouton pour SodaStream Fizzi

Bouton de remplacement pour SodaStream modèle Fizzi. J'ai également réduit le jeu de fonctionnement et fait en sorte que ça libère le gaz un peu plus tôt lors de l'appui, aligné un peu plus le ressors pour le fonctionnement. J'ai imprimé…

Downloads
128
Likes
11
Rating
0
P
Printableslokthelok

Sodastream Fizzi Button Replacement

Button Replacement for Sodastream Fizzi - remixed from great work by eboy23 STEP provided for easy editing. Print Settings: Printed on MK4 with 0.2mm STRUCTURAL Profile. I upped infill to 25%, and set to 3 perimeters. I printed at 45…

Downloads
108
Likes
3
Rating
0
P
PrintablesEl_Taco_Loco

Extension base for Sodastream Fizzi

I switched from sodastream CO2 canisters to a 5lb tank. The instructions for the hose kit recommended drilling a hole in the back cover of the Sodastream. I created this base with a notch for the CO2 hose. The model was printed in PLA…

Downloads
35
Likes
4
Rating
0
P
PrintablesBlake Haas

Soda Stream Fizzi Base with hole for C02 hose

I quickly whipped up this base for a soda stream fizzi model. The goal was to have an extension on the bottom that allowed a C02 hose to connect to a larger tank. I could have just left the back off or drilled a hole in it, but what is…

Downloads
23
Likes
1
Rating
0
P
PrintablesTime Warp Labs

SodaStream Fizzi Drip Guard

The SodaStream Fizzi model has a habit of dribbling water after you remove the bottle. A little water doesn't hurt the unit itself, but it runs onto whatever table or shelf it sits on, leaving spots and possibly damaging the surface over…

Downloads
10
Likes
0
Rating
0
P
Printables

Sodastream Fizzi Button Replacement

Button Replacement for Sodastream Fizzi - remixed from great work by eboy23 STEP provided for easy editing. Print Settings: Printed on MK4 with 0.2mm STRUCTURAL Profile. I upped infill to 25%, and set to 3 perimeters. I printed at 45…