Mikrotik HEX RB750Gr3 Vertical Mount
Printed using eSUN PLA+ Black
- Downloads
- 114
- Likes
- 9
- Rating
- 0
Counting matching models…
Printed using eSUN PLA+ Black
Protective case for the Ricoh GRiiix or GRiii camera. It's designed to print-in-place with a flexible hinge. 4-6mm of cushy TPU surround the camera and provide good protection while keeping a lean profile in your bag. I printed mine out…
Introduction When I decided to assemble my HomeLab Rack I wanted each device to have its own dedicated holder, as I like to keep everything tidy and wanted to avoid a mass of shelves. Unfortunately I couldn't find any satisfactory…
I started working with 3D for a litle time, I did not find any Mikrotik rb750gr3 for 10 inch rack, so I made my own.
Hello, this is my simple Rack Mount for Mikrotik RB750 Gr3 HEX. I designed this mount to use 1U space ( little bit less to allow some play) Mount is made very thick and sturdy to allow pluging and unpluging of cables without holding…
1U 10-inch rack mount for a MikroTik RouterBoard RB750Gr3 (installed without its case) and one Raspberry Pi 4 or 5. Requires M3 nuts and bolts for mounting the MikroTik RouterBoard. Requires M2.5 bolts for mounting the Raspberry Pi.…
Makes holding camera a little easier, short and long versions available. Might fit other cameras. Fairly sturdy in PLA but obviously 3D printed thumb grip isn't going to be as strong as a metal one, use at your own risk. Printing…
New version - better grip, increase polygon quality. The top and bottom are the same height so you can print two of the same and use them like this. Required: 6x2mm magnets
The top and bottom are the same height so you can print two of the same and use them like this. Required: 6x2mm magnets - 4 pc
Always seems like theres nowhere to put the antenna wire when installing different electronics. This fixs that issue.
This a Ricoh GR3x camera holder for Honeycomb Storage Wall Print settings: Supports: YES, bed only 0.2mm layer height, PETG 这是一个用于 蜂窝挂钩系统 的理光GR3x相机的挂架 打印设置: 支撑:是,仅在打印版生成 0.2mm层高,PETG
Replacement rollers for lower rack on Hotpoint HDF330PGR3BB dishwasher. I own a Hotpoint HDF330PGR3BB dishwasher. One of the rollers for the lower rack fell off and it looks like it sat on the heating element for quite a while as I found…
I've built a few cyberdecks over the years. Pelican case jobs mostly, the knd that look great on a desk but are a pain to actually use in the wild. Too bulky, awkward power setups, not really something you'd pull out in a coffee shop…
I added 4040 Rail Mounts and a pair of tie loops. Print Settings Printer: Mingda Rafts: No Supports: Yes Resolution: 200 Infill: 20 Filament: unknowen PLA Category: 3D Printer Accessories
Just an Oc i have. It was about time for him to be figurized. Yes i went all out on the title render. I will do this for many other ocs. His lore is significantly enough different. The swords in his shoulders are called "SoulBounds".…
Just an Oc i have. It was about time for him to be figurized. Yes i went all out on the title render. I will do this for many other ocs. His lore is significantly enough different. The swords in his shoulders are called "SoulBounds".…
Print in PETG with tree supports. Praise Gr33nguy. (XD)