Imam Husain Shrine Haram
A Simplified version of the Shrine of Imam Husain in Karbala.
- Downloads
- 207
- Likes
- 13
- Rating
- 5
Counting matching models…
A Simplified version of the Shrine of Imam Husain in Karbala.
This is a photogrammetry 3D scan that I edited for 3D printing. It is a statue of Arethusa at the Louvre scanned by Benjamin Bardou. I smoothed and sculpted some areas and filled holes. I also scaled and oriented the model. The original…
Sadam Husain Rolls-Royce Corniche
Model je kombinací kreslení a tvorby v tinkercadu. Nakreslili jsme požadovaný tvar a poté ho exportovali do inkscapu. Odtud jsme ho převedli do formátu SVG. Tento formát byl importován do tinkercadu a výška nastavena na požadovanou…
This is a speedo holder for a Koso DB01RN for Husaberg 70° models with all wiring instructions. I made a 0° and 10° holder. You need to check which angle is better for you (because of reflection and the “bad” viewing angle of the display…
Vytvořil jsem úpravou model husy s otvorem na panáka a vytiskl. Panáka jsem tisknul pomocí vázového nastavení.
Husa Držák na příbory POKUD SE MODEL LÍBÍ DEJTE PROSÍM LIKE A STAHUJTE DĚKUJI
one of the biggest challenges was to design the pelisse was the use the articulation of the dummy 13 while looking like the regiment and I think it turned out well note- the pelisse is only a shoulder piece and you still need to print out…
I recommend printing with 0.12mm, ideally with 0.08mm. That's due to the models small size.
The sliding part is, I think, fragile (onto the shelf) → would be better to choose another material or change the propositions of the model :) CP
I was heart broken when I adjusted my desk lamp for the last time and the handle broke away from its head. It was surprising to see a design that put so much responsibility on bit of a plastic piece. It’s the Ikea HUSÅ lamp that uses a…
This is a holder for two Koso Coin temperature displays for the Husaberg 70° FS / FE 390 450 570. It fits perfectly (with the original hole) and holds very well in place. I would recommend to make it from ASA or ASA-CF to make it…
This is a holder for two Koso Coin temperature displays for the Husaberg 70° FS / FE 390 450 570. It fits perfectly (with the original hole) and holds very well in place. I would recommend to make it from ASA or ASA-CF to make it…
Husa Držák na příbory POKUD SE MODEL LÍBÍ DEJTE PROSÍM LIKE A STAHUJTE DĚKUJI