KLR650 Keyring
No funny settings is needed. Just print it slow to make sure you get the detail. Category: 3D Printing
- Downloads
- 56
- Likes
- 4
- Rating
- 5
11 models
No funny settings is needed. Just print it slow to make sure you get the detail. Category: 3D Printing
A small and simple container that carries two glass cartridge fuses. I made it so that I can carry two spare fuses for my KLR650 in my onboard toolbox. Because the glass bodies of the fuses are fragile, I decided to sink them completely…
Simple seal driver and backing support for installing a water pump mechanical seal into your KLR650 engine cover. Designed to be used with a 5/16ths bolt. Be sure to use washers on the prints to spread out the load and use a high infill…
I designed this to replace the bulky rubber knob on the shift lever of a gen3 KLR650. When running boots I had a hard time shifting, this resolved the issue along with a relief cut on the shifter allowing it to drop one more spline. Print…
Uses an M5 nut on the back. Print in TPU. These should probably only be used temporarily. Category: Automotive
The infamous "doohickey" modeled for fun. Doos: Make a keychain, Show your friends what you mean by "did the doo", remix into doo benchy. Doo'nts: Use as a replacement for your KLR, Ingest, or insert rectally. Enjoy
A quick and simple spacer for the gen 3 KLR650s seat. The screws and subsequently spacers rattled off mine and after replacing them a few times I said screw it. These fit perfectly and were designed to be used with m6x30 thumb screws but…
Printable replacements for those annoying plastic washers that go missing on the gen3 KLR650's fairing and windshield screws. Replaces Kawasaki PN: 92200a and 92200
Lost or misplaced the grommet collar for your KLR650? This is part replaces Kawasaki part # 92027-1183. This collar is pressed into the rubber grommets in the lower fairings where it bolts to the fuel tank. Installing the fairing without…
This spacer lowers the front fender on the KLR650 to better clear the radiator and frame. Some aftermarket front fenders have a shallower angle than OEM past the head tube which can cause them to rub. This spacer lowers the front fender…