7 models
A Filament Roll to replace a broken Filament Roll. Printed without top and bottom layers and honeycomb Infill will make this look gorgeous.
Print approx. €3.98–€4.87 excl. taxPreliminary estimate for one variant
Just repaired the cab of my Pool chemical float Print Settings Printer Brand: Prusa Printer: I3 MK3S Rafts: No Supports: No Resolution: 0.15 Infill: 15 Filament: das fillament PETG Category: Replacement Parts
It is replacement for handle mount of ikea drawer Printed without supports, 0.2mm layer height, pla
The Lid on Da'Bomb - The Final Answer - Original Hot Sauce It comes broken/cracked more time than not from Amazon shipping going off of all the reviews on amazon I designed a replacement to replace the ones that are shipped broken/cracked…
These are the pins for the cross bars on the Honey Can-Do rack. I had the heads break off a few of the injection molded originals. These are a bit stronger with some design improvements. MAKE SURE TO PRINT 2 OF THE FILE. This file is only…
friend lost her plastic peices that hold on her oven handle. made them out of high temp pla because i cant get abs to print right on my ender 3. still a work in progress this is only the second prototype that i am making to test on her…
Rubber ones wore out and wasps were making nests in tubes, so made a replacement plug. Tight fit especially if lots of rust inside tubes (i printed in ASA). Just light tapping with hammer gets them in.
